Boiler Inspections - 3 PDH

Course Description

This course provides guidance for the inspection of steam and hot water boilers and unfired pressure vessels. In addition to boilers, inspection and testing is discussed for carbon dioxide and liquid petroleum gas vessels, heat exchangers, and deaerators.

Course Outline

1. INSPECTION AND TEST FREQUENCIES

2. UNFIRED PRESSURE VESSELS

3. BOILER INSPECTIONS

4. UNFIRED PRESSURE VESSEL INSPECTIONS

5. PRESSURE TESTS

6. OPERATIONAL TESTS

7. REPAIRS AND ALTERATIONS

8. INSPECTION CERTIFICATES AND REPORTS

9. MAXIMUM ALLOWABLE WORKING PRESSURE

Learning Objectives

Upon completion of this course you will:

• • Learn the required frequency of inspection and testing of heat exchangers operating over and under 250 psig;

  • Learn the fundamentals of pressure test;

  • Learn when hydrostatic testing is required;

• • Learn about special inspections required for steam boilers;

  • Learn the special considerations when repairs are made to steam boilers as a result of inspection and testing;

• • Learn the requirements for boilers testing and inspection in dry layup; and

  • Learn about the appropriate codes that apply to testing and inspection.

Intended Audience

This course is intended for mechanical engineers looking for an introduction to inspecting and testing boilers, unfired pressure vessels, and associated equipment to assure safe operation.

Benefit for Attendee

This course will give mechanical engineers an introduction to the fundamentals of inspecting and testing operational unfired pressure vessels and boilers.

Course Introduction

This is an introduction to testing and inspection of steam and hot water boilers, unfired pressure vessels and associated equipment.

Course Summary

This course will give you guidance you can apply in operating and maintaining boilers and pressure vessels safely and efficiently.